Sony YS-DX516P Bedienungsanleitung Seite 43

MON.1 OUT
(A)
(B)
(C)
(D)
(E)
(A) FULL (Default setting):
If an alarm trigger is received, the picture from the
camera corresponding to the alarm input will be
displayed full screen.
• DOUBLE ALARM (Default setting: LAST)
When using the "FULL" setting at the "MON.1
OUT" line, the following settings are possible.
LAST: When triggers from multiple cameras are
received in full screen mode, the picture from the
camera of the last alarm received is displayed.
FIRST:When triggers from multiple cameras are
received in full screen mode, the picture from the
camera of the first alarm received only is
displayed. Camera pictures from subsequent alarm
triggers will not be displayed.
SWITCH:When triggers from multiple cameras are
received in full screen mode, the picture from each
concerned camera will be displayed sequentially
at 1 second interval.
(B) MULTI16:
When an alarm trigger is received, the display will
switch to a 16 divisions screen.
(C) MULTI9:
When an alarm trigger is received, the display will
switch to a 9 divisions screen. However, if the alarm
trigger is at a camera other that the ones displayed in 9
divisions screen, the picture from the concerned
camera is not displayed.
(D) POST:
When an alarm is activated, the screen changes to a
QUAD screen and displays the still images
immediately after an alarm trigger was input. The still
images are displayed in either the upper-left, upper-
right or lower left screen. The current moving image is
finally displayed in the lower-right screen.
• DOUBLE ALARM (Default setting: LAST)
When using the "POST" (SWITCH setting is
disabled) setting at the "MON.1 OUT" line, the
following settings are possible.
LAST: When triggers from multiple cameras are
received in full screen mode, the picture from the
camera of the last alarm received is displayed.
FIRST:When triggers from multiple cameras are
received in full screen mode, the picture from the
camera of the first alarm received only is
displayed. Camera pictures from subsequent alarm
triggers will not be displayed.
(E) NC:
The display mode will remain unchanged when an
alarm trigger is received.
MON.2 OUT (Default setting: OFF)
ON: Monitor 2 display will switch to full screen
alarm display, when an alarm trigger is received.
OFF: Monitor 2 display will not change.
43
(GB)