Inhaltsverzeichnis
Werbung
Drilling
At the start of drilling select a lower speed to avoid the drill bit slipping
away from the desired hole location.
If the drill-hole is deep, the drill-bit may become jammed in the hole. In this
case a high torque could damage the drill bit or the drill. If the bit becomes
jammed, hold the machine firmly and immediately release the ON/OFF
trigger. Use the rotating direction button (4) to switch to counter clockwise
rotation and use a low rotation speed to remove the jammed drill bit more
easily.
Screwing
Before using the machine check whether the screw bit is inserted correctly.
Avoid over-tightening, otherwise the screw head may be damaged or
stripping of the threads may occur.
Use the rotating direction button (4) to set up the rotion in clockwise
direction. Insert the screw-bit into the slot in the head of the screw. Hold the
screw bit right to the head of the screw, otherwise the screw or the screw
head may be damaged. Press the screw bit against the screw with a
constant pressure while driving in the screw. Start screwing with a low
rotation speed.
To unscrew, set the rotating direction counter clockwise. Insert the screw
bit into the slot in the head of the screw. Hold the screw-bit right to the head
of the screw, otherwise the screw or the screw head may be damaged.
Press the screw bit against the screw with a constant pressure while
removing the screw.
Battery Level Indicator
The battery level indicator (9) is located on one side of the housing.
The 3 LEDs indicate the battery level:
1 LED (red): = 30% +/-5% capacity
2 LEDs (red + yellow): = 60% +/-5% capacity
3 LEDs: (red + yellow + green) =
90% +/-5% capacity
For checking the battery level
status, press the button (10). If only
the red LED turns on, charge the
battery.
Operating
18
Werbung
Inhaltsverzeichnis
