Inhaltsverzeichnis
Werbung
The cordless screwdriver has a keyless drill chuck (1) so you do not need a
key to lock the tool bit in place. Make sure the drill or screw bit is not jammed
when you insert the tool and tighten the
chuck.
1. To open the chuck (1) hold the ring
firmly and turn the chuck counter
clockwise until you can insert the
tool.
2. Insert the drill/screw bit all the way
in and then turn the chuck clock-
wise hand tight. This will automati-
cally lock the drill chuck.
3. To release the locking and to
remove the tool, turn the chuck
counter clockwise.
Setting up the Torque
1. With the torque setting ring (2) you can set
up the maximum torque. The higher the
number on the setting ring, the higher the
selected torque will be.
2. When starting to work, set the torque to a
low value. When the set torque is reached,
the clutch is released and the work piece can
not be damaged.
3. When the torque setting ring is set to the drill
symbol, the clutch is locked and can not slip.
Setting up the Gear
1. This cordless screwdriver is equipped with a two gear transmission. With
the gear switch (3) on top of the machine you can change between both
gears.
2. Use the high speed (drill symbol) for drilling and the lower speed (screw
symbol) for driving screws.
Note: Only operate the gear switch when the motor has halted completely.
Operating
17
Chuck
Ring
Werbung
Inhaltsverzeichnis
