Westfalia 67 42 67 Bedienungsanleitung Seite 26

PART C: Compass Point
1. Secure one of the parallel guide rods into the rear channel of the base
plate.
2. Remove the locking nut from the front channel of the parallel guide and
secure it into the additional rod locking point.
3. Loosen the wing screw of the compass point and slide the compass point
onto the rod end.
4. Adjust the point height to suit before locking the wing screw again.
5. Adjust the distance between the router bit (12) and compass point. Now
you can make with the router a circle in the workpiece.
Accessory
22