Inhaltsverzeichnis
Werbung
Before first Use
Unpack the router and check all parts for any damage in transit. Dispose of
packaging materials or store it out of reach of children. Plastic bags etc. may
become a deadly toy for children.
Power Mains Connection
Make sure the mains voltage is the same as the operating voltage indicated on
the rating plate.
Switching ON/OFF
The machine is equipped with a safety release button (2). To switch on the
machine, fist press the safety release button (2) and afterwards press the
ON/OFF switch (13). After switching on the machine you can release the
safety release button.
The safety release button helps to prevent any unintended operation.
Inserting the Milling Cutter
1. Make sure that the collet and the shank of the milling cutter (12) are of the
same size. The machine is supplied with collets for 8 and 12 mm tool
shafts.
2. Press the spindle lock (11) and unscrew the collet nut and insert the milling
cutter (12). The milling cutter shank must be inserted at least 20 mm into
the collet.
3. Press the spindle-lock (11) and tighten the collet nut tightly with the
included fork spanner. Never tighten the collet nut with the fork spanner
without first inserting a milling cutter.
4. Run machine up to full no load speed before using and watch out for
vibration or wobbling that could indicate unbalance.
Setting the Milling Depth
1. Place the router onto the work-piece.
2. Set the stepped depth control stop (7) to the lowest step by rotating it by
hand.
Operation
17
Werbung
Inhaltsverzeichnis
