Westfalia 86 63 22 Bedienungsanleitung Seite 14

2. Pull out the belt by means of the
hook (A) from the retractable end of
the ratchet up to the desired length
and attach the hook to a proper
anchor point.
3. Fasten the fixed hook (D) to another
suitable anchor point.
4. Depress the red button (B) to remove
any slack.
5. Lift up the ratchet handle (C) to get
the lashing position. Move the ratchet
handle up
webbing is tight.
Be careful not to over-tighten the
webbing and damage the load.
6. Once the load is secure, close the
ratchet handle down to lock (locking
position).
Release
Before opening the tie down make sure that the load remains fast
even without restraint and cannot fall down. If necessary attach
further load-securing devices, in order to prevent the load from
falling down.
1. Simultaneously press the red button (B) and the ratchet handle
(C) and move down up to the end to the fully open retractable
position (the unwinding position).
2. Grip the hook on the retracting end and remove from the anchor
point.
3. Depress the red button (B) to recoil the webbing into the ratchet.
and down
Using
until the
14
Position for Lashing
Locking Position