Westfalia 86 63 22 Bedienungsanleitung Seite 13

General Hints
 Please always take into account the required traction together
with the usage type and the type of load to be lashed when
selecting and using tie downs. The size, shape and weight of the
load determine the correct selection, but also the intended usage
type, the transportation environment and the type of load. For
reasons of stability, at least two tie downs must be used for tying
down and two pairs of lashing straps for diagonal lashing.
 Make sure the selected tie down is both strong and long enough
for the intended use and are of the correct length concerning the
lashing type.
 Due to varying behaviour and due to length changes under
stress, varying load-restraint devices (e.g. lashing chains and tie
downs made of chemical fibres) must not be used to lash the
same load. If additional fitting parts and lashing devices are
used, make sure that these are appropriate for the tie down.
 Protect the tie down against friction and abrasion and against
damage due to loads with sharp edges by means of protective
covers and/or edge protectors.
A
Tie Down
1. Simultaneously
button (B) and the ratchet handle
(C) and move down up to the end
to the fully open retractable position
(the unwinding position).
Using
press the
13
B
C
red
Unwinding Position
D