Inhaltsverzeichnis
Werbung
Option 1: Weed Killer
Assembly of the telescopic extension handle:
1. Attach the extension handle to the
device. Make sure that the exten-
sion handle firmly clicks into posi-
tion. The telescopic extension
handle can be adjusted easily to
the required length.
2. Turn knob A, reposition the handle to the desired length and then turn
knob A securely.
If using the device as a weed killer you must use the extension handle.
Hold the weed killer firmly by holding the end of the extension handle!
Operation
1. Ensure the extension handle is firmly fixed onto the device and that the
device is turned off.
2. Turn the device to position 1.
3. Install the nozzle (11) to destroy weeds.
4. Insert the plug into the socket.
5. Make sure the nozzle is not blocked before turning the device on.
6. Set the temperature to setting II or III.
7. Allow the device about 45 seconds to warm up.
8. To eliminate weeds, hold the nozzle over the weeds for about
5 seconds. During this time the cell structure of the weed is destroyed.
As a result, the weed dies within a few days.
It is not necessary to completely burn the weeds, 5 seconds is more
than sufficient.
For an efficient treatment the nozzle should be held around 0 to 5 cm
above the weeds
The effects are not visible immediately but will take a while before they
can be seen. It is more of a long-term effect.
Operation
21
Werbung
Inhaltsverzeichnis
