General Information; Registering Sub Monitors; Using Repeaters - Panasonic VL-SWD501EX Bedienungsanleitung

10.1 Registering sub monitors

Additional sub monitors (additional accessories, ®
page 4) can be registered and used with this product.
10.1.1 Registering a sub monitor to the main
monitor
1
: From the top menu, touch
® [Register/Cancel] ® [Register] ® [Sub
monitor station] ® select the number of the sub
monitor to be registered.
R After this, use the sub monitor and complete the
following steps within about 2 minutes.
2
*1
: When "Please register the device." is displayed
on the sub monitor screen, press
(Yes).
R "Registering completed" is displayed.
3
: Press
*1 To re-register cancelled sub monitors:
) ®
(
) ®
( (Yes)

10.2 Using repeaters

If the sub monitor or camera are used away from the
main monitor, or if there are obstructions (® page 7)
between the sub monitor or camera and the main
monitor, the following problems may occur. In these
cases, using a repeater (additional accessory, ®
page 4) may improve transmissions between the
devices.
– calls with the sub monitor cut out and images are
distorted
– images from the camera are distorted or notifications
from camera sensors cannot be received
– When is displayed for the sub monitor or the
camera's indicator lamp flashes in red, the main
monitor cannot connect to the sub monitor or camera
Note:
R Up to 2 repeaters can be used. A single repeater can
be used to send signals to multiple sub monitors or
cameras. However, the same repeater cannot send
signals to both sub monitors and cameras.
R Signal range differs depending on factors such as the
structure of rooms or the types of walls used. After
®
) ®
(
.
: "Register" ®
registering devices to the main monitor (®
page 40), see the repeater's Getting Started for
information about appropriate installation locations.
Signal range and repeater installation example
Using each repeater connected separately
This extends signals away from the main monitor.
Because signals are sent through the main monitor,
different types of devices can be connected to each
repeater. (For example, sub monitors can be connected
to one repeater and cameras can be connected to
another.) This is useful when you want to connect to
different types of devices over shorter distances.
When repeaters are not used:
When repeaters are used:
Using 2 repeaters connected together
This extends the signal away from the main monitor by
sending signals directly between repeaters. Because the
signals are sent between repeaters, the same type of
device must be connected to both repeaters (all sub
monitors or all cameras). This is useful when you want
to connect to the same type of devices over long
distances.

10. General information

39