Maintenance And Care - Mato pneuMATO 55 Lube-Jet Betriebsanleitung

Operating manual
pneuMATO 55 Lube-Jet
the grease containers.
- Place dust protection cover onto the bucket with grease sequence cover.
- Push the pumping station support down until you reach the dust protection cover and secure
with a wing nut.
- Push the pumping station through the pumping station support, the dust protection cover and the
grease sequence cover until it reaches the grease container base. Secure pumping station with
wing nut.
- Connect double hose to the pump and the spray gun.
- Check all connections for a firm fit and leaks before starting the system.
- Connect air connection to the air pump and ensure that no more than 5 bar of air pressure is
pending at the pump. Once the air supply is established, the pump independently sucks in the
lubricating grease. Keep gun now open, until the lubricating grease comes out. Afterwards
release trigger. The pump will automatically shut off after reaching the maximum operating
pressure and is ready for use.
- When the system is not in use turn off the air supply to the pump. Relieve pressure on the high-
pressure hose by operating the spray gun.
Observe safety instructions.
6

Maintenance and care:

Maintenance, inspection and repair work must only be performed by qualified personnel.
Regularly check the pressure regulator preset to 5 bar.
The system must not be operated at a pressure higher than 5 bar
The air link is to be removed before any repair or maintenance work, and after each use,
furthermore grease pressure on the delivery hose is to be relieved by pressing the trigger lever
on the grease gun.
Regularly check the pressure-bearing components (high pressure hose) for any damage or
wear. Defective parts must be replaced immediately with genuine parts.
For instructions for maintenance of the spray gun, please refer to the separately enclosed
manual.
Ordering spare parts:
When ordering spare parts the following information is required:
Type specification, designation of the ET, order number
The following maintenance periods should be strictly observed to ensure trouble-free operation.
High pressure hose
Checking for loose
connections
Legibility and availability of
information
Spray gun
Pressure limiter
/ Benzstr. 16-24 / 63165 Mühlheim a. Main / Tel:+49(0)6108-906-0 / Fax:+49(0)6108-906-120
GmbH & Co. KG
MATO
Before each use
X
X
X
Annually Observe manufacturer's
information and the hazard
assessment of the operator.
X
X
X
X
11