Operation - AL-KO Snow Line 700E Betriebsanleitung

GB

Operation

Danger - risk of injury!
Wear work clothing and protective gear.
▪ Winter clothing
▪ Non-slip winter shoes
▪ Eye protection (safety glasses or visor)
▪ Hearing protection
Starting operation
1. Prepare the snow blower for operation.
2. Check the position of the snow discharge chu-
te and adjust the snow discharge direction using
the hand crank (
3. Adjust the snow discharge height (
4. Start the engine.
5. Set the wheel drive speed (
6. The forward speeds range from 1 to 6, 1 being
the slowest speed and 6 the fastest speed.
7. The reverse speeds are R1 and R2, R1 being
the slower speed and R2 the faster speed.
8. Press the auger drive clutch lever (
Danger – risk of severe injury!
Keep away from the augers while they are in
motion. Keep other persons or animals away.
9. Press the wheel drive clutch lever (
» The snow blower starts moving.
Stopping operation
1. Release (disengage) the auger and wheel drive
clutch levers in (
„ In order to prevent freezing, continue running
the auger and impeller until they are largely free
of snow.
» The snow blower stops moving and
the auger and impeller stop running.
32
25 -1).
25 -2).
26 -3):
26-4).
27-5).
28).
Changing the wheel drive speed
1. Release (disengage) the auger and wheel drive
clutch levers in (
Change the drive speed only when di-
„
sengaged in order to avoid damaging the
machine.
2. Change the drive speed using the speed selec-
tor
( 29 -1).
Unclogging the snow discharge chute
If snow does not discharge properly, the augers or
the discharge chute may be clogged with snow or
ice.
1. Release (disengage) the auger and wheel drive
clutch levers in (
2. Switch off the engine.
3. Disconnect the spark plug connector.
4. Carefully remove the snow from the snow di-
scharge chute and auger using the snow
cleaning tool ( 30-1).
If snow still does not discharge properly, contact a
qualified workshop.
Steering the caterpillar tread snowblower
Pull the left or right rocker lever (
ving to steer the caterpillar tread snowblower to the
left or right.
Adjusting the height of the auger drive and plate
(760TE)
Using the lever ( B), the height of the auger drive,
the clearing plate and the shield can be adjusted by
shifting the weight of the snowblower.
To operate, set the lever to Normal .
Packed Snow ( B-9): For "packed snow", the
weight lies more in the front area of the snowblower
so that more pressure is created.
Normal ( B-10): Horizontal position of the caterpil-
lar treads for normal operation.
Transport ( B-11): The weight lies more to the
rear so that the snowblower and shield are removed
from the ground and can be pushed easily.
AL-KO snow blowers
28).
28).
B-5) while dri-
Original operating instructions