Getting Ready For Operation - AL-KO Snow Line 560 II Betriebsanleitung

Snow Line 560 II, 620 II, 620E II
Safety
Warning!
Never leave the engine running in an enclosed
space. Risk of poisoning!
„ Store petrol and oil only in appropriate containers.
„ Allow the machine to cool before storing it in an
enclosed space.
„ If there is still petrol in the tank, make sure that
there is no ignition source in the enclosed space,
such as a heater or clothes dryer.
„ Add or empty petrol and oil in an open space only
when the engine is switched off and cold.
„ Do not overfill the tank (petrol expands).
„ Do not smoke while filling the tank.
„ Do not open the tank cap while the engine is run-
ning or hot.
„ Replace the tank or cap if damaged.
„ Always secure the tank cap securely.
„ If petrol has spilled out:
Do not start the engine
„
Do not attempt ignition
„
Collect spilled petrol with a binding agent or
„
cloth and dispose of appropriately.
Clean the machine
„
„ If engine oil has spilled out:
Do not start the engine
„
Collect spilled petrol with an oil binding
„
agent or cloth and dispose of appropriately.
Clean the machine
„
When disposing of used oil:
▪ do not throw into the rubbish
▪ do not pour into sewers or drains or onto the
ground
We recommend returning used oil in a closed con-
tainer to a recycling facility or service centre.
469186_e
Adding engine oil
1. Remove the oil cap (
clean area.
2. Add oil using a funnel.
3. Check the oil level.
4. Replace the oil cap tightly and clean.
See the engine manual for information about checking
the oil level.
Adding petrol
1. Remove the tank cap (
clean area.
2. Add petrol using a funnel.
3. Replace the tank cap tightly and clean.

Getting ready for operation

Caution!
Do not operate a damaged machine!
Perform a visual inspection before using.
The camera symbol on the following pages
references the illustrations on pages 4–7.
Adjusting the clearance height
Danger - risk of injury!
Adjust the clearance height only if the engine
is switched off and the auger is not in motion!
▪ Adjust the clearance height to avoid taking
in gravel or other objects.
▪ Look out for uneven places such as ruts,
manhole covers or paving stones.
1. Place the machine on an level surface.
2. Loosen the left and right skid plate clamping
screws (
3. Raise the clearing plate to the desired height
and attach the skid plates. Make sure that both
skid plates are spaced equally so that the clear-
ing plate runs parallel to the ground (
Autogoods "130"
22 -1) and store in a
22 -2) and store in a
23-1).
GB
23-2).
27