User Interface / Settings - EKOM DK50 4VR/50/M Benutzerhandbuch

AD DRYER
Operator's position. No specific operator's position is required. The operator may remain within
range of a visual warning signal depending on actual operating conditions.
Low pressure. This signal is active when the dryer pressure sensor reads low pressure in the dryer
under the defined limit of 3 bar. An air leak from the compressor/dryer, malfunction of the control
solenoid valves on the dryer or a software error may activate this alarm during operation.
High pressure. This signal is active when the dryer pressure sensor reads an increase in pressure
over the high limit. The air pump will then shut down and remain shut-down until the pressure
decreases. If the aggregate does not shut down, excess pressure is vented by the safety valve on
the compressor's air tank.
High dew point. This signal is active when the dew point sensor reads a high dew point value.
Expiration of service interval. This signal is activated until service is performed and the interval
reset, or a new service interval is entered.

20. USER INTERFACE / SETTINGS

20.1. Meaning of symbols on the display
Symbol representing the user manual, or to read the user manual.
Symbol expressing the ambient temperature (from 25°C) related to the selected
mode.
The program adjusts the chamber pre-filling in the given mode.
Symbol expressing the ambient temperature (from 25°C to 30°C) related to the
selected mode.
The program adjusts the chamber pre-filling in the given mode.
Symbol expressing the ambient temperature (over 30°C) related to the selected
mode.
The program adjusts the chamber pre-filling in the given mode.
Back to the main menu on the 4 main screens.
Go back
Symbol for the service interval
Symbol for when the dryer chamber is currently in regeneration
Symbol for when the dryer chamber is currently drying
03/2022 57 NP-DK50 4VR 50, DK50 2x4VR 110-AD-1_03-2022