Status Codes - Bosch Rexroth PSI 6 C 225-Serie Typspezifische Anleitung

70/83 Bosch Rexroth AG

Status codes

of the inputs „Fault reset", "Reset fault with Weld complete" or "Reset fault and
reweld" is activated.
8 Status codes
Tab. 11: Status codes
Code (decimal) Meaning
00 OK
80 Stop circuit open / no +24 V
81 Weld without command
85 Memory deleted == RAM checksum error
86 Data download active
87 no welding program == invalid parameters
88 Hardware fault
89 I/O bus fault (only for timers with a serial I/O bus)
90 Halfwave monitoring
91 Main switch tripped
92 External temperature too high
93 Synchronization error
94 Start inhibited
95 Program parity error
98 Programmed value too large
99 Welding process error
100 Supply voltage fault
160 Excessive heat sink temperature
164 Transformer temperature too high
165 Hardware fault driver module
166 24V Supply voltage fault
182 Dressing tool control not OK
224 Dressing result not OK after first check
225 Dressing result not OK after second check
3106 Q-Stop component
3107 Q-Stop spot in series
3108 Q-Stop special spot
3109 UIP: Violation of the absolute lower tolerance level
3110 PSF: Violation of the absolute lower tolerance level
3111 UIP: Violation of the absolute upper tolerance level
3112 FQF: Violation of the absolute lower tolerance level
3113 FQF: Violation of the absolute upper tolerance level
R911334336 | PSI 6xCx.225