Cable Routing / Brake - Rocky Mountain FUSION POWERPLAY Bedienungsanleitung

36
Fusion Powerplay Platform Manual
CABLE ROUTING
• Remove rubber grommet (alloy) on the right side of the downtube.
Remove old housing and cable.
• Working from BACK to FRONT, insert shift housing at the rear of the chainstay assembly.
• Run the shift housing in the cable tray, and into the downtube.
• Run the shift housing all the way to the front of the bike and out the port.
• Run the shift housing in the cable collector, pull taut, and fix the cable collector in the downtube with the 3 mm hex screw.
• Fasten cables and wires to the cable tray on the drive side of the motor with zip ties.
• Install the main pivot cable guide.
• Trim and adjust shift cable and housing.
• Reinstall port or rubber grommet over the shift housing.
• Reinstall battery.