Configuring The Network Interface; Configuring The Global Network Settings - G&D VisionXS-IP-C-DP-HR Installation Und Bedienung

Configuring the network interface

How to configure the network interface:
1. Use the remote hotkey
2. Select the entry Network setup
3. Select the entry Interfaces
4. Enter the following data under
Operational
mode:
IP address:
Netmask:
5. Press F2 to save your settings.

Configuring the global network settings

Even in complex networks global network settings ensure that the KVM extender is
available from all partial networks.
How to configure global network settings:
1. Use the remote hotkey
2. Select the entry
Network setup
3. Select the entry Interfaces
Establishing a KVM-over-IP™ connection for the first time
+ to open the OSD.
Ctrl Num
and press Enter
and press Enter .
Interface A :
Press F8 to select the operational mode of the interface:
 Static: A static IP address is assigned.
 DHCP: IP address is obtained from a DHCP server.
switches off network interface.
 Off:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
Ctrl + Num to open the OSD of computer module.
and press
Enter
and press Enter .
.
.
G&D VisionXS-IP-C-DP-HR · 28