Fitting The Cladding (Steel And Stone) - Olsberg OSORNO Montageanleitung

Installation instructions
EN
for the specialist company
● ●
Fig. 2.7 Flue gas routing from above
Fig. 2.8 Removing the cover for flue gas routing through the rear wall
Fig. 2.9 Flue gas routing through the rear side
Install flue pipe
● Install the pipe liner (on site) in the chimney! The connection
height can be set individually.
● Plug the flue pipe (provided by the customer) onto the Ø 150 mm
connection pipe of the stove! The stove pipe can be connected
either at the top or at the back.
40

2.7 Fitting the cladding (steel and stone)

● Only use the original cladding set!
● Start with the lower cladding in each case!
5 m m
M6x20
Fig. 2.10 Fitting the side steel cladding at the bottom
reinschieben
insert
retirer
2x
5 m m
M6x20
rausziehen
pull out
insérer
2x
4
2x
M6x10
Fig. 2.11 Fitting the front steel cladding at the bottom
OSORNO / OSORNO S
4x
M6x10
We reserve the right to make technical changes
4