Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance, Overhaul, Repair
EN
10
Maintenance, Overhaul, Repair
EN
EN
10.1 Maintenance
• Consult the relevant national regulations to determine the type and extent of
EN
inspections.
EN
• Adapt inspection intervals to the operating conditions.
EN
EN
At a minimum, check the following points during maintenance work on the device:
• Firm fit of the conductors,
EN
• Damage on the enclosure, seals or surface,
EN
• Dirt on the sleeves,
EN
• Compliance with the permissible temperatures (according to IEC/EN 60079),
• Whether the device is used in accordance with its intended use.
EN
EN
10.2 Overhaul
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
10.3 Repair
EN
EN
18
SolConeX Coupler socket, 32 A
Series 8571/16
Overheating and explosion hazard due to defective switching contacts!
Non-compliance results in severe or fatal injuries.
• Replace the entire socket flange after each short circuit in the
main circuit of the switch because the state of the switching
contacts cannot be checked in hermetically sealed equipment.
Observe the relevant national regulations in the country of use.
Explosion hazard due to improper repair!
Non-compliance results in severe or fatal injuries.
• Repair work on the devices must be performed only by
R. STAHL Schaltgeräte GmbH.
Explosion hazard due to improper repair!
Non-compliance results in severe or fatal injuries.
• Hermetically sealed connections are to be repaired only in
conformity with the manufacturer's description.
• Repairs are not permitted based on the values in Table 2 or 3
of standard IEC 60079-1:2014.
DANGER
DANGER
DANGER
276210 / 8571645300
2020-11-03·BA00·III·en·00
Werbung
Inhaltsverzeichnis
