Stahl SolConeX 8571/16 Serie Betriebsanleitung Seite 36

Mounting and Installation
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Main contacts
EN
EN
EN
EN
EN
EN
EN
EN
EN
16
SolConeX Coupler socket, 32 A
Series 8571/16
Two conductors can be installed under one connection terminal.
Material and cross section of both conductors must be identical.
The conductors can be connected without any special preparations.
A [mm] B [mm]
200 12
• Open the enclosure.
• Guide the conductors through the
cable entry and into the connection
chamber.
• Strip the conductors.
• Insert the conductors into
the corresponding terminals
and clamp them
(for tightening torque,
see chapter "Technical data").
11201E00
Insert the stripped cable ends
completely under the terminal.
• Check if the conductors have
been clamped properly.
• Align the conductors. Make sure
that the clamping units are not
under tension.
• Tighten the cable entry/entries.
• Close the enclosure
(for the tightening torque,
see chapter "Technical data").
276210 / 8571645300
2020-11-03·BA00·III·en·00