Software support
10
Software support
An easy to operate software package is available for all your espressoDAQ
modules. catman
lization, as well as exporting measurement data in commonly used formats.
The package also includes a LabVIEW
.NET / .COM API for self-programmers.
10.1 LabVIEW
HBM provides a driver to integrate the espressoDAQ modules into the Lab-
VIEW
graphic programming system.
The LabVIEW
components are virtual instruments (VIs) or sub-programs,
that are used in LabVIEW
components are used to initialize, open and close the interfaces, to initialize
and configure the modules, to make settings, to trigger and query measure-
ments, etc.
10.1.1Installation
Before installing "espressoDAQ for LabVIEW" on your computer, make sure
that LabVIEW (min. version 2009) is already installed on your computer.
Use Windows Explorer to start the installation manually. To do this, launch
the Setup.exe. program. Then follow the software installation instructions.
The "espressoDAQ for LabVIEW" installation package covers not only the ac-
tual installation, but also:
the installation of the "HBM espressoDAQ USB driver"
the installation of "Microsoft Visual C++ Redistributable" and
the installation of the "Microsoft .Net Framework 2.0 Runtime" (if this is not
yet installed on your computer).
When you uninstall espressoDAQ for LabVIEW, these additional installation
packages are not automatically removed from your system!
If necessary, you must remove these packages manually (using the control
panel/software).
A2888−1.1 en/de
Starter is used for configuration, data acquisition and visua-
-driver
programs to operate the modules. The library
-driver and libraries, as well as a
59