Preliminary Operations - FAR KJ 45/S Bedienungsanleitung-Ersatzteillisten

KJ 45/S
PRELIMINARY OPERATIONS (fig. f2-f3)
Check that the threaded tie rod (A) and head (B) couple
assembled on the riveting tool is suitable to the size of the
insert to clamp; otherwise change the size (page 37). The
tie-rod (A)/head (B) unit assembled on this riveting tool,
corresponds to a M10 thread.
Before using the riveting tool and after each change of size, the
stroke should be adjusted according to the dimensions, type
of the insert and thickness of the material to clamp. Before
carrying out this operation rotate the knob (M) according
to the direction of the arrow, (+) for increasing the stroke
and (-) for decreasing it. Increasing the stroke - rotation of
knob (M) - in the direction indicated with the symbol (+), the
distance "h" (page 31) decreases increasing the clamping
action. To verify that the stroke is correctly adjusted check the
indicator (N) comparing it with the values of the table (fig. f3).
NOTE: Before the definitive placing of the insert, its clamping
on the thicknesses involved should be checked, carrying
out other adjustments, as shown at page 40 (the specified
adjustments are just an indication, it is advisable to see the
technical data of the inserts used).
ATTENTION! The incorrect adjustment of the
riveting tool can cause a bad clamping of the
inserts and a possible break of the tie rod!
ATTENTION! The above-mentioned operations
must be done when the tool is not fed. For
visualizing the changed stroke (N) the tool
must be fed.
f3
M12
1 ÷ 4
15
Corsa tirante max.
Tie rod max. stroke Revolutions (M)
~ 8 mm
10
11
12
13
14
Giri (M) Corsa tirante
Tie rod stroke
15 ~ 0.4 mm
75036018 - KJ45 S – rev 12- ( 09-2022)
GB
f2
15
M
8 7
9 6
Giri (M)
Revolutions (M)
1
N
0
5
4
3
2
1
0
Corsa tirante min.
Tie rod min. stroke
~ 2 mm
15
0
B
A
Giri (M)
Revolutions (M)
0
27