Tool Master (Tool No. 1)" And "Tool Offset (Tool No. 2 ~); (Lathe Applications) - Magnescale LH70 Bedienungsanleitung

7. Operation Method

7-2-8. "Tool Master (Tool No. 1)" and "Tool Offset (Tool No. 2 ~)"

(Lathe Applications)

Tool master (tool No. 1)
A tool master is a datum point used when setting the tool offset.
<Setting and calling a tool master>
1
Press the key. (
2
Press the key corresponding to the axis to be set.
If a tool master is already set, the numerical value of the
previously set tool master is displayed.
3
Use the numeric key to enter the value.
* When you want to use a value that was set previously, there is
no need to enter the value using the numeric key. Proceed to
step 4.
4
Use the key to finalize the setting.
The current value becomes the value of the tool master.
When the tool master is set, the set value is stored in the
memory.
5
Press the key.
The system exits the tool master. (
<Editing a tool master>
You can edit a stored tool master.
1
Press the key. (
2
Press the key.
3
Press the key corresponding to the axis to be edited.
4
Use the numeric key to enter the value.
5
Use the key to finalize the setting.
(Tool master value 20 is stored in No. 1.)
6
Press the key.
Tool master editing is completed.
* When using an edited tool master, carry out <Setting and
calling a tool master>.
Note
ABS indicator remains on during datum point mode.
The tool master (No. 1) is used as the basis of linear compensation.
(Position of tool master value 0 = Compensation amount 0)
7-10
(E)
lamp lights up)
lamp goes out)
lamp lights up)
Display
(Current value
display)
(Example: 100.000)
Display
(Current value
display)
(The tool master
value for each axis
is displayed.)
(Example: 20.000)
LH70