Addition Display Selection (Only Avairable When Selecting Lathe Function); Preset Mode - Magnescale LH70 Bedienungsanleitung

7-2-5. Addition Display Selection (Only Available When Selecting Lathe
Function)
These operations can be performed when the mode lamps are not lit.
How to cancel: Press the
See "5-4. Verifying Count Values during Addition Display".

7-2-6. Preset Mode

<Setting the preset values>
1
Press the key. (
2
Press the key corresponding to the axis to be set.
3
Use the numeric key to enter the value.
4
Use the key to finalize the setting.
The current value becomes the set preset value.
5
<Setting the next preset values (max 3 values for each axis)>
Press the key corresponding to the axis to be set.
Press the key.
Perform step 3 and 4.
6
Press the key.
The system exits the preset mode. (
<Calling a preset values>
1
Press the key. (
2
Press the key corresponding to the axis to be called.
The preset value is displayed.
When multiple preset values are set, press the
display the next value.
3
Press the key.
The preset value is finalized, and the current value becomes the
set preset value.
4
Press the key.
The system exits the preset mode. (
Note
The INC indication remains on during preset mode.
LH70
key when selecting axis (the axis label will be flashing).
lamp lights up)
lamp goes out)
lamp lights up)
key to
lamp goes out)
Display
(Current value
display)
(Example:
10.000)
Display
(Current value
display)
7. Operation Method
7-3
(E)