Description Of Detailed Settings - Magnescale LH70 Bedienungsanleitung

5. Settings

5-1-3. Description of Detailed Settings

This sets the polarity, display resolution, compensation values, and other settings for the actual operating
conditions.
When the power is turned on for the first time after factory shipping, the "detailed settings" cannot be made
unless the "basic settings" have been completed.
If the "basic settings" are set or changed, all of the "detailed settings" will revert to the
factory default settings.
* If you have already entered the "detailed settings", make a note of the setting values before resetting or
changing the "basic settings".
Setting item Factory setting
Automatic setting
Minimum display for measuring unit
resolution resolution values
Measuring
unit input Display
Display switching 1 –––––––––– 1
(2-axis and 3-axis 2 –––––––––– 2
models with 3 –––––––––– 3
general-purpose/
milling machine
specifications only)
DisplayAxis label
Axis label 1 –––––––––– X
switching (1-axis 2 –––––––––– Y
and 2-axis models 3 –––––––––– Z
with general-
purpose/milling
machine function
only)
Compensation
value
Flicker control
Sleep
5-2
(E)
Available options
Measuring unit resolution and higher
Diameter display (except for angle
display)
Polarity (+/–)
: Measuring unit input 1
: Measuring unit input 2
: Measuring unit input 3
: Nothing displayed
Display 1...X/Z
Display 2...Y/Z
Display 3...Z
1-axis model 2-axis model
X
Y
Z
X or Z X
or
Y
: No setting
: (Enter the linear
compensation value)
: No setting
: Weak
: Strong
: No setting
: 1 minute
: 5 minutes
: 10 minutes
: 30 minutes
: 60 minutes
Remarks
This sets the resolution that is
displayed. The setting may vary
depending on the setting for the
measuring unit resolution in the
"basic settings".
For the lathe function, the diameter
display can be used to display twice
the amount of the cut of a cutting
tool. Set the polarity so that the
value of the cutting direction (X-axis)
decreases.
During diameter display, φ will light
up in lamp display mode.
* Pressing the
you to add the type of minimum
display resolution.
This is the measuring unit input and
display 1/2/3 combination. The count
display location (display 1/2/3) can
be changed without reconnecting
the measuring unit input. The
respective settings are linked to the
selected option.
This is the display 1/2/3 and axis
label combination.
X Z
or
Z Y
* See Part 5-5, "Compensation".
Reducing display flicker.
OFF status shows the most accurate
status.
The display is turned off if no
operations are performed for a
preset time.
key enables
LH70