Before Start-Up; Pushing The Machine; Batteries / Chargers; Warning Symbols - Kärcher KM 100/120 R Bp Originalbetriebsanleitung

● Clean the inside of the machine, see chapter Cleaning the in-
terior of the machine
● Remove/install the right rear wheel, see chapter Removing/in-
stalling the rear wheel
1. Switch off the machine, see chapter Switching off the ma-
chine.
Open the left/right cladding:
2. Grasp the recessed grip at the front of the left/right-hand clad-
ding, lift slightly and swing the left/right-hand cladding to the
side.
Illustration D
Shown on the left-hand cladding of a KM 100/120 R G
Close the left/right cladding:
3. Swing back the left/right-hand cladding until it audibly engages
on the machine.
Storage area
The maximum permissible load on the storage compartments is
20 kg.
1 Ensure that the load is securely fastened.

Before start-up

Unload the machine
DANGER
Risk of injury and damage when loading the machine!
When loading the machine, there is a risk of injury from the ma-
chine rolling away, tipping over and falling.
When loading, take into account the weight and dimensions of
the machine and use a suitable ramp.
When loading, secure the machine against rolling away, tipping
over and falling.
Do not use a forklift for loading.
Load the machine only on level, horizontal ground.
On uphill and downhill slopes, move the machine only with the
machine's own travel drive, never by pushing.
Dimensions, weights and maximum climbing ability see chapter
Technical data.
Illustration E
Figure: Installing the ramp
1. Cut the plastic packing tapes and remove the packing films.
2. Make the machine ready to drive:
a KM 100/120 R Bp: Install and connect a battery, see chapter
Installing/connecting/removing the battery.
b KM 100/120 R Bp pack: Connect the power supply, see
chapter Disconnecting/connecting the power supply.
c If necessary, charge the battery, see chapter Charging the
battery.
3. Remove the tensioning strap fastening at the eyelet points.
4. Unscrew the three boards shown and the squared timber on
the pallet.
5. Position the boards on the edge of the pallet; align the boards
so that they are flush with the wheels of the machine. Screw
the boards tightly to the pallet.
6. Place the squared timber under the boards as a support.
7. Remove the wooden blocks on the wheels.
8. Carefully drive the machine off the pallet via the ramp created,
see chapter Driving the machine.

Pushing the machine

WARNING
Risk of injury and damage when releasing or activating the
parking brake due to the machine rolling away!
When releasing or activating the parking brake, the machine can
roll away and roll over or jam/crush people, animals or body parts.
Before releasing or activating the parking brake, secure the ma-
chine against rolling away with chocks.
Only release the parking brake when the machine is standing on
level and horizontal ground.
Only push the machine on level ground, never on uphill and
downhill slopes.
Only move the machine on uphill and downhill slopes using the
machine's own drive.
Immediately after each push, secure the machine again with
chocks to prevent it from rolling away.
When pushing, take into account the weight and dimensions of
the machine, enlist help if necessary.
1. Before pushing the machine, read the chapter Releasing/ac-
tivating the parking brake read!

Batteries / chargers

ATTENTION
Only use the batteries and chargers recommended by the
manufacturer
Only replace batteries with batteries of the same type.
Before disposing of the vehicle, remove the battery and dispose
of it in accordance with national or local regulations.
Observe the following warnings when handling the batteries:
Observe notes in the instructions for the battery, on
the battery and in these operating instructions.
Wear eye protection.
Keep acids and batteries away from children.
Risk of explosion
Fire, sparks, open flames and smoking are prohibited.
Risk of acid burns
First aid
Warning
Disposal
Do not throw batteries in the bin.
DANGER
Risk of fire and explosion
Do not place tools or other objects on the battery.
Naked flames and smoking must be strictly avoided.
Ensure the room is well ventilated when charging batteries.
Only use batteries and chargers approved by Kärcher (original
spare parts).
WARNING
Environmental risk due to improper disposal of batteries
Ensure that defect or used batteries are disposed of safely (con-
tact a waste management company or Kärcher Service).
English

Warning symbols

Safety instructions
23