SICK DAX Schnellstartanleitung Seite 35

8028139/2022-11-22 | SICK
Subject to change without notice
2
±0.5
(0.02)
1
50
(1.97)
3
Figure 6: Dimensions and distances for MAG-B-180-xx position magnet on DAX® Slider
Nominal distance + permissible amount of distance tolerance
1
Permissible center offset
2
Recommendation: M5 x 20
3
2
±5
(0.20)
1
50
(1.97)
3
Figure 7: Dimensions and distances for MAG-B-180-xx position magnet on DAX® Slider
Nominal distance + permissible amount of distance tolerance
1
Permissible center offset
2
Recommendation: M5 x 20
3
Misalignments are compensated for via the air gap.
•
Surface pressure of the position magnet: Type-dependent, see the technical data
of the position magnet used.
• Tightening torque for the M4 screws: Max. 1 Nm, use washers if necessary.
CAUTION
Mount the C-magnets concentrically.
Mount the block magnets centered over the linear encoder profile. Do not exceed the
maximum permissible air gap. Install the sensor so that the sensor rod/linear encoder
profile is aligned parallel to the direction of movement of the position magnet. In this
way, you avoid damage to the magnet driver, magnet, and linear encoder profile.
QUICKSTART
Q U I C K S T A R T | DAX® 35
en