Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.9.2
Protective cover
The spindle head is equipped with a pro-
tective cover.
WARNING!
Only remove the protective cover
when the mains plug of the drilling
milling machine is disconnected.
1.9.3
Master switch
In the "0" position, the lockable master switch can be secured against unauthorised or non-
authorised switching on by means of a padlock.
When the master switch is switched off, the power supply to the motors is interrupted.
Except for the areas marked by the pictogram in the margin. In these areas there might be volt-
age, even if the main switch is switched-off.
1.9.4
Cross table
The cross table has slots for T-nuts.
WARNING!
Risk of injury due to workpieces flying off at high speed. Securely fix the workpiece on
the drilling table.
1.9.5
Drill- mill chuck protection
Set the drill- mill chuck protection to the
required height.
Close the drill- mill chuck guard before
you start milling or drilling.
The drilling and milling machine can
only be switched on if the chuck guard
is closed.
1.9.6
Prohibition, warning and mandatory signs
INFORMATION
All warning signs must be legible. They must be checked regularly.
1.10
Safety check
Check the drilling and milling machine at least once per shift. Inform the person responsible
immediately of any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
EN
DH 40CT
62
Protective cover
Drill- mill chuck
protection
Translation of original instruction
Img.1-1:
Protective cover
Img.1-2:
Spindle protection
Version 1.0.1 - 2021-07-06
Safety
Werbung
Inhaltsverzeichnis
