Safety Check; Personal Protective Equipment - Optimum OPTImill MH 25 SV Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
1.10

Safety check

Check the milling machine at regular intervals.
Check all safety devices
before each operation,

once a week (with the machine in operation),

after all maintenance and repair work.

General check
Equipment
Guards
Signs,
Markers
Functional check
Equipment
Emergency stop mushroom
button
Separation guard around the
drilling and milling spindle
1.11

Personal protective equipment

For certain work personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personal protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personal protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
GB MH25SV
Page 62
Check
Mounted, firmly bolted and not damaged
Installed and legible
Check
When the emergency stop mushroom button is activated, the milling
machine must switch off. It is only possible to restart the machine if the
emergency stop mushroom button is unlocked and the ON switch is
activated.
The milling machine should only switch on when the guard is closed.
Original operating instructions
OK
OK
Version 1.0.1 dated 2015-12-17