Connecting Usb Flash Drives; Connecting To An External Medical Imaging Recorder; Printing Images Via External Medical Printer - Ambu aBox 2 Bedienungsanleitung

12.2. Connecting USB Flash Drives

If needed, connect an external USB flash drive to the USB ports on the front or back of the
displaying unit (see section 2.4. for USB port locations).

12.3. Connecting to an External Medical Imaging Recorder

If needed, connect an external medical imaging recorder to one of the video out ports
(3G-SDI or DVI-D) located on the back of the displaying unit.
It is also possible to transfer trigger signals to the imaging recorder via the Trigger out ports
A, B (3.5 mm jack), C or D (D-SUB9) located on the back of the displaying unit. See chapter 8 for
instructions on how to view and reconfigure which functions are transmitted via the Trigger
out ports.
Connecting video output to a medical imaging recorder:
•
Connect a DVI-D or 3G-SDI cable to video output group 2 on the back of the displaying
unit. See section 2.4. for Video out port locations.
•
Connect the other end of the DVI-D or 3G-SDI cable to the corresponding video-in port on
the medical imaging recorder.
Connecting trigger output to a medical imaging recorder:
• Connect a 3.5 mm jack or D-SUB9 cable to the trigger output channel you wish to use
(A, B, C or D). See section 2.4. for Trigger out port locations.
•
Connect the other end of the cable to the corresponding trigger input port on the medical
imaging recorder.
Note: It is important that the assigned function on the trigger output port of the displaying unit
matches the function assigned to the connected input port of the medical imaging recorder.

12.4. Printing images via external medical printer

Before you print images via a medical printer, ensure that USB connection has been enabled
for printing and a medical printer has been connected via USB (see section 5.3.).
Select settings for printing:
• Press the Settings tab,
then press Setup.
•
Press Printer settings.
• Press the required page size
Print images via medical printer:
• Press the Archive tab,
then press Procedures.
• Press the required procedure folder.
• Select the required images by ticking the boxes below the thumbnails
Select all
3 .
• Press the export icon
•
Ensure that the printer name is shown below the export icon to verify that connection has
been established
• Press Print
.
7
.
1
, then press Basic
4
.
6
5
3
0:00:07
1
.
5
2
, or press
2
4
6
7
Print
33