Transport; Remaining Hazards; Electrical Connections - Scheppach ox t500 Original Anleitungen

working aids for bracing.
be carried out when the motor is switched off. Pull the
power supply plug.
cal installation my be carried out only by qualified per-
sonnel.
completing repair and maintenance procedures.
pull the power supply plug.
scheppach machine. Thus you increase the risk of ac-
cidents.
rective.
horizontal position. Wood may only be split while hori-
zontal and in the direction of the grain. Dimensions of
wood to be split:
position.
instructions as well as the technical data given in the
calibrations and dimensions must be adhered to.
erally recognized safety and technical rules must also be
adhered to.
by trained persons who are familiar with the machine
ized modifications of the machine exclude a liability of
the manufacturer for damages resulting from the modifi-
cations.
manufacturer excludes any liability for resulting dam-
ages, the risk is exclusively borne by the user.
The machine has been built using modern technology and
in accordance with recognized safety rules.
Some hazards, however, may still remain.
hands by improper feeding or placement of wood.
ing or feeding.
to elctrical injuries.
the entire operating manual.
8 english
ox t500 Innen.indd 8
Proper Use
maximal 52 cm.

Remaining hazards

Transport

-
To remove the machine from the palette, two persons will
be required.
The machine may be transported while held in a diagonal
chine stands on its wheels.
Your scheppach machine can be stored or transported un-
Prepare the workplace where the machine is to be placed.
- Ensure sufficient room to allow safe work without malfunc-
tions.
The machine is designed to operate on a level surface and
must be placed securely on firm, level ground.
Please make sure your scheppach machine is placed firmly
on stable plain ground.
Assembly
the customer.
-
the delivery.
Place the device horizontally on the floor, and put the Sty-
ropor pad of the packaging underneath the splitting wedge
side.
-

Electrical connections

es. Please make sure that the connection lines are discon-
nected from the mains supply during the check. Electrical
regulations and the provisions of the local power supply
The labeling of the connection cable with the type specifi-
cation is required.
Damaged electrical connections
Often, insulation damages occur on electrical connection
lines.
- The possible causes are:
door clearances. .
- nection line.
line out of the wall socket.
fective electrical connection lines must not be used and
are, due to the insulation damages, life threatening!
Single phase motor 230 V/50 Hz
minimum cross section of 1.5 mm², lines with a length
exceeding 25 m must have a minimum cross section of
-
Setup
-
-
-
15.09.11 12:45