Elektra Beckum Hobbymaster KS 250 Betriebsanleitung Seite 19

A
Danger of injury!
The fence must always be fitted when cutting.
Otherwise the workpiece can be caught by
the rotating saw blade and hurled away.
The workpiece must be free of tension (or
else the workpiece will jump upon completion
of the cut, or the saw blade jams).
Table extensions
With the table extensions larger workpieces can be
cut without risk that they fall down upon completion
of the cut.
In addition, the fence stop is fastened to the table
extension as well.
Fence stop and fence plate
With the help of fence stop and fence plate, several
workpieces can be successively cut to exactly the
same length.
KS 250
Stopping lever
By means of the stopping lever the saw blade is
locked for a blade change.
A
Danger!
Never depress the stopping lever unless the
power supply cable has been unplugged and
the saw blade is has not stopped spinning!
The locking device can be damaged when it
is engaged while the saw blade is still turning.
Locking pin
The sawhead can be locked in the "down" position
using the locking pin . This can be useful after work
is finished or for purposes of transportation.
Commissioning
Table extension installation
1. Lower the sawhead and and lock it in the down
position with the retention pin.
2. Carefully turn the saw over and place it on a suit-
able surface so that it is not damaged.
3. Slide fence stop onto the tabel extension as
shown.
2.4