Welding; Maintenance And Cleaning - Parkside PISG 100 A1 Bedienungs- Und Sicherheitshinweise

 Welding
Choose between push and drag welding. The following section shows the impact of the direction of
movement on the properties of the weld seam:
Burn
Weld seam width
Weld bead
Weld seam fault
NOTE: You decide for yourself which type of welding is most suitable, once you have welded a
sample piece.
NOTE: Once it has worn down completely, the electrode must be replaced.
 Maintenance and cleaning
NOTE: The welder must be regularly serviced and overhauled for proper function and for compliance
with the safety requirements. Improper and wrong operation may cause failures and damage to the
device.
Before performing cleaning work on the welding tool, disconnect the power cable

outlet to ensure the tool is safely isolated from the power supply.
Clean the exterior of the welder and its accessories regularly. Use compressed air, cotton waste or a

brush to remove dirt and dust.
NOTE: The following kinds of maintenance work must be performed only by suitably-qualifi ed
personnel.
The current regulator, earthing device and internal cables must be serviced regularly.

Check the insulation resistance levels of the welder regularly. To do this use an appropriate

measuring device.
In case of a defect or a necessary replacement of equipment parts, please contact the appropriate

qualifi ed personnel.
Push welding
smaller
larger
fl atter
larger
Drag welding
larger
smaller
higher
smaller
from the power
10
GB/IE/NI 17