Emc Device Classifi Cation; Warning Notice - Parkside PISG 100 A1 Bedienungs- Und Sicherheitshinweise

PROTECTION AGAINST RAYS AND BURNS
Warn of the danger to the eyes by hanging up a sign saying

"Caution! Do not look into fl ames!". The workplaces must be
shielded so that the persons in the vicinity are protected. Unauthorised
persons must be kept away from welding work.
The walls in the immediate vicinity of fi xed workplaces should

neither be bright coloured or shiny. Windows up to head height
must be protected to prevent rays from penetrating or refl ecting
through them, e.g. by using suitable paint.
 EMC Device Classifi cation
According to the standard IEC 60974-10, this is a welder in elec-
tromagnetic compatibility Class A. Class A devices are devices that
are suitable for use in all other areas except living areas and areas
that are directly connected to a low-voltage supply mains that (also)
supplies residential buildings. Class A devices must adhere to the
Class A limit values.
WARNING NOTICE: Class A devices are intended for use in
an industrial environment. Due to the power-related as well as the
radiated interference variables, diffi culties might arise in ensuring
electromagnetic compatibility in other environments.
Even if the device complies with the emission limit values in accord-
ance with the standard, such devices can still cause electromagnetic
interference in sensitive systems and devices. The user is responsible
for faults caused by the arc while working, and the user must take
suitable protective measures. In doing so, the user must consider the
following:
power cables, control, signal and telecommunication lines
–
computer and other microprocessor controlled devices
–
television, radio and other playback devices
–
electronic and electrical safety equipment
–
persons with cardiac pacemakers or hearing aids
–
measurement and calibration devices
–
noise immunity of other devices in the vicinity
–
the time of day at which the work is being done.
–
The following is recommended to reduce possible interference radiation:
fi t a mains fi lter to the mains connection
–
service the device regularly and keep it in good condition
–
welding cables should be completely unwound and installed
–
parallel on the fl oor, if possible
14 GB/IE/NI