Measure And Cut The New Hose; Install The Hose Fittings - Rock Shox XLoc Full Sprint Bedienungsanleitung

M e a s u r e a n d C u t t h e N e w H o s e
1. Route the rear hose along or through the frame to the rear shock. Leave a gentle bend in the
hose from the frame to the handlebar.
2. Use an Avid® Hydraulic Hose Cutter Tool to cut the hose to the desired length.
I n s t a l l t h e H o s e F i t t i n g s
1. Slide the Connectamajig, large opening first, along the hose and onto the Connect host
fitting.
2. Apply Slick Honey® to the hose barb threads, the new compression fitting outer surfaces, and
the compression nut threads.
3. Slide the hose boot onto the hose, small opening end first. Slide the compression nut onto
the hose, non-threaded end first.
4. Use an Avid Hydraulic Hose Barb Driver Tool or a T10 TORX® wrench to thread the new hose
barb into the end of the hose until it stops.
5. Slide a new compression fitting over the end of the hose and hose barb.
1
4
T10
5

Measure and Cut the new hose

11