4. After adapting the appliance to another type of gas or to another pressure, other than that for
which it had been previously set, the old instructions should be replaced with the instructions
for the new settings, to enable unambiguous identification of the state of the appliance after
modification.
Burner
4.7
Water connection
The general installation must have a stop-cock. The water inlets are defined in the "General
dimensions and connections" section with the letter A.
The recommended water pressure is between 2 and 4 bar and the maximum temperature is 60°C
The water inlets on the appliances are ½".
The appliance is installed in accordance with the EN 1717 standard and national water regulations.
4.8
Recycling
The product packaging consists of:
A wooden pallet
Cardboard edge protectors.
A polypropylene band
A plastic bag.
All the packaging used around the machine can be recycled; The correct disposal of these products
will help to protect the environment. For further information regarding the recycling of these products,
please refer to the relevant office of the local government. Dispose of these materials in accordance
with current legislation.
5. INSTRUCTIONS FOR USE AND MAINTENANCE
BEFORE STARTING THE APPLIANCE, PLEASE READ THE INSTRUCTIONS
CONTAINED IN THIS MANUAL CAREFULLY.
THIS APPLIANCE IS EXCLUSIVELY FOR PROFESSIONAL USE, AND SHOULD
ONLY BE USED BY QUALIFIED PERSONNEL.
5.1
Risks of use
c. Remove the pilot injectors and replace with the correct model according to the gas
to be used (Table 3).
d. Replace the pilot unit.
You are using a pasta cooker; do not use this appliance for anything other than
what it is designed for, as its operating components may be damaged.
Frequently check the tubs' filling level.
It if is insufficiently filled, the temperature may rise too high causing the
appliance to overheat.
Too much water may cause the hot water to spill out with the
subsequent risk of burns.
If you are going to use solvents or inflammable cleaning products to remove
Ignition pipe
Pilot
26