Water Connection; Waste Water Connection - Fagor ADVANCE PLUS APG-061 Installationshandbuch

INSTALLATION MANUAL ADVANCE PLUS
ENGLISH

WATER CONNECTION

3/4"
A B C D
The water used should have the following properties:
Recommended filters:
A) Fine filter.
If the water contains impurities such as sand, iron particles or floating
substances, we recommend the use of a fine filter at the water input.
B) Activated carbon filter.
If the water has a high chlorine content over 0.2 mg/l (ppm) (this
information can be obtained from the relevant water board), an activated carbon
filter should be installed.
C) Installation of osmosis recirculation.
When the chloride concentration is above 150 mg/l (ppm) (this
information can be obtained from the relevant water board), an osmosis
recirculation installation should be mounted. In this case, please remember that
the minimum conductivity value is 400 µS/cm.
D) Water descaling:
For water with a high level of limescale (without chloride load) the water should
be treated. Systems: H+. Interchange of ions or Kleensteam. We strongly
advise against the use of sodium exchangers (normally used in dish washers)
due to the formation of sodium sediment and the delay in boiling with common
salt.
For the selection of the filter systems (A, B, C, D), it is recommended the
manufacturer Britta.
Warning: Before connection, look at the label that shows which is the water
inlet.
1
300kPa
R3/4"
3/4"
Manguera entrada agua
Water inlet hose FIG 12
PH 6.5÷7.5
Chlorides < 150mg/litre
Chlorine concentration 0.2÷0.5 mg/litre
Conductivity 400÷1000 µS
Water impurities Ø < 0.08 mm
Water hardness 5-10ºF
30
Only connect drinking water to the
appliance.
Connect the appliance to the mains
water supply at point 1 (fig 12) using
the hose supplied.
The pressure of the incoming water
should be between 400 and 400 kPa
2
(2-4 kg/mm ). We recommend 250 kPa.