Inhaltsverzeichnis
Werbung
CDI MAGNETO
2. Install:
Woodruff key 1
Rotor 2
NOTE:
Clean the tapered portions of the crankshaft
and rotor.
When installing the woodruff key, make sure
that its flat surface a is in parallel with the
crankshaft center line b.
When installing the rotor, align the keyway c
of the rotor with the woodruff key.
3. Install:
Plain washer
Nut (rotor) 1
Use the rotor holding tool 2.
Rotor holding tool:
YU-01235/90890-01235
4. Connect:
CDI magneto lead
Refer to "CABLE ROUTING DIA-
GRAM" section in the CHAPTER 2.
5. Install:
Gasket [crankcase cover (left)]
Crankcase cover (left) 1
Hose holder (cylinder head breather
hose) 2
Screw [crankcase cover (left)]
NOTE:
Tighten the screws in stage, using a crisscross
pattern.
4 - 72
ENG
48 Nm (4.8 m · kg, 35 ft · lb)
New
10 Nm (1.0 m · kg, 7.2 ft · lb)
Werbung
Inhaltsverzeichnis
