Servicing The Tool; Daily Servicing; Weekly Servicing; Service Kit - Stanley ESAFOR MK II Anleitung

O R I G I N A L I N S T R U C T I O N

5. SERVICING THE TOOL

Regular servicing should be carried out and a comprehensive inspection performed annually or every 500,000 cycles,
whichever is sooner.
CAUTION: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
CAUTION: Before maintenance, remove any dangerous substances that may have accumulated due to work
processes.
CAUTION: The employer is responsible for ensuring that tool maintenance instructions are given to the
appropriate personnel.
CAUTION: The operator should not be involved in maintenance or repair of the tool unless properly trained.
CAUTION: The tool shall be examined regularly for damage and malfunction.
CAUTION: Read Safety Instructions on page 4 to 6.

5.1 DAILY SERVICING

• Daily, before use or when first putting the tool into service, pour a few drops of clean, light lubricating oil into the
air inlet of the tool if no lubricator is fitted on air supply. If the tool is in continuous use, the air hose should be
disconnected from the main air supply and the tool lubricated every two to three hours.
• Check for air leaks. If damaged, hoses and couplings should be replaced by new items.
• If there is no filter on the pressure regulator, bleed the air line to clear it of accumulated dirt or water before connecting
air hose to tool.
• Check that the nose assembly is correct.
• Check the stroke of the tool is correct.
• Inspect the punch in the nose assembly for wear or damage. If any, renew.

5.2 WEEKLY SERVICING

* Check for oil leaks and air leaks on air supply hose and fittings.

5.3 SERVICE KIT

For all servicing we recommend the use of the service kit (part number 74290-03000) tools below:
Description
Spanner 32 mm
Spanner 20 mm
(part of outfit)
Vice with soft jaws
Flat-nose pliers
Spanner 10 mm
Tubular socket wrench
25 mm
Allen key 12 mm
SERVICE TOOLS
Part
For part No. 18
For part No. 7
For part No. 37
For part No. 12
For part No. 73
For part No. 62
For part No. 64
Description
Allan key 5 mm
Allan key 2 mm
Spanner 12 mm
Hook device
Spanner 17 mm
Spanner 22 mm
Pin Punch
E N G L I S H
Part
For part No. 35
For part No. 33
For part No. 75
For part No. 83, 28
For part No. 31
For part No. 4
For part No. 38
13