Operating Basics; Add A Channel Waveform To The Display - Tektronix 2 Serie Schnellstartanleitung

Operating basics

Add a channel waveform to the display

Use this procedure to add a channel signal to the Waveform View.
1. Connect signal(s) to the channel input(s).
2. Tap an Inactive Channel button (in the Settings bar) of a connected channel.
The selected channel is added to the Waveform View and a Channel badge is added to the Settings bar.
3. Continue tapping Inactive Channel buttons to add more channels (analog). Channels are displayed from lowest-numbered channel at
the top, to highest-numbered channel at the bottom of the view, regardless of the order they were added (in stacked mode).
4. Double-tap a channel badge to open that channel's configuration menu to check or change settings. See
waveform settings on page 43.
MSO24, MSO22 2 Series Mixed Signal Oscilloscopes Quick Start Manual
Operating basics
Configure channel or
42