Operating Requirements - Tektronix DPO70000SX Serie Installations- Und Sicherheitshandbuch

Product end-of-life handling
Observe the following guidelines when recycling an instrument or component:
Equipment recycling
This symbol indicates that this product complies with the applicable European Union requirements according to Directives
2012/19/EU and 2006/66/EC on waste electrical and electronic equipment (WEEE) and batteries. For information about
recycling options, check the Tektronix Web site (www.tek.com/productrecycling).
Battery disposal or recycling
Perchlorate materials

Operating requirements

Warning:
To prevent injury and instrument damage, do not operate the instrument while the instrument is resting on its rear feet.
1. Place the instrument on a cart or bench. The instrument should rest on its bottom feet. An optional rack mounting kit is available.
Observe the following clearance requirements and dimensions:
• Top: 0 in (0 mm)
• Left side: 3 in (76 mm)
• Right side: 3 in (76 mm)
• Rear: 3 in (76 cm) beyond the rear feet to protect any cables connected to the rear panel
• Bottom: 0 in (0 mm) standing on feet, flip stands down
CAUTION: To ensure proper cooling, keep the bottom and sides of the instrument clear of obstructions.
To ensure proper cooling, if the instruments are stacked on top of each other, the bottom feet must remain on the instruments.
2. Width: 19.0 inches (483 mm)
3. Height: 6.0 inches (152 mm)
4. Before operating the instrument, verify the ambient temperature: 5 °C to +45 °C (+41 °F to +113 °F)
5. Verify the operating humidity: 8% to 80% relative humidity at up to +32 °C (+90 °F)
5% to 45% relative humidity above +32 °C (+90 °F) up to +45 °C (+113 °F), noncondensing, and is limited by a maximum wet-bulb
temperature of +29.4 °C (+85 °F) (derate relative humidity to 32% at +45 °C (+113 °F))
6. Verify the operating altitude: 3,000 m (9,843 feet), derate maximum operating temperature by 1 °C per 300 meters (984.25 feet) above
1500 meters (4921.25 feet) altitude.
7. Maximum input voltage:
TekConnect channels: ≤1.2 V/FS settings:
±1.5 V relative to the termination bias (30 mA maximum).
Production of this equipment required the extraction and use of natural resources. The
equipment may contain substances that could be harmful to the environment or human health
if improperly handled at the product's end of life. To avoid release of such substances into
the environment and to reduce the use of natural resources, we encourage you to recycle
this product in an appropriate system that will ensure that most of the materials are reused or
recycled appropriately.
This product contains a small installed lithium metal button cell. Please properly dispose of or
recycle the cell at its end of life according to local government regulations.
This product contains one or more type CR lithium batteries. According to the state of
California, CR lithium batteries are classified as perchlorate materials and require special
handling. See www.dtsc.ca.gov/hazardouswaste/perchlorate
Operating requirements
for additional information.
7