JUNO JB126S2 Benutzerinformation Seite 26

Step 7
Hold the door glass panels by their top
edge and carefully pull them out one by
one. Start from the top panel. Make sure
the glass slides out of the supports com‐
pletely.
Step 8
Clean the glass panels with water and soap. Dry the glass panels carefully. Do not clean the
Step 9
If the door is installed correctly, you will hear a click when closing the latches.
Make sure that you put the glass panels (A and B)
back in the correct sequence. Check for the sym‐
bol / printing on the side of the glass panel, each of
the glass panels looks different to make the disas‐
sembly and assembly easier.
When installed correctly the door trim clicks.
Make sure that you install the middle panel of glass
in the seats correctly.
13.6 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
26 ENGLISH
glass panels in the dishwasher.
After cleaning, install the glass panels and the oven door.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
A B
Step 3
Put a cloth on the bottom of the
cavity.
A
B