Oil Drainage Hp- Pump; Oil Filling Hp- Pump; Carry Away Used Oil; Touch Panel / Glass Plate / Glass Walls - Dibo SBH-E Originalbetriebsanleitung

E N
S E R V I C E
9

Oil drainage HP- pump

• Put a oil trough under the drain plug.
• Remove the drain plug. Let all the oil in the oil trough.
• Assemble the drain plug (with a new packing ring).
10 Oil filling HP- pump
Remove the oil-level gauge. Flll the engine crankcase with oil until the oil-level
comes up to the middle of the gauge (type oil see technical data). Check the oil-
level on the basis of the marks on the oil-level gauge. Place back the oil- level
gauge.
11

Carry away used oil

Pour the tapped oil in a can.
Deliver the tapped oil by your dealership or at the proper authorities.
12

Touch panel / glass plate / glass walls

• Clean the touch panel (in technical room , on electric panel) regularly. This can
be done by a soft cloth. The cloth may be moistened with water WITHOUT
soap or other possible additives to protect the protective foil on the touch
panel. If an aggressive / corrosive agent will be used, the protective foil is
damaged, and the screen will be unclear or damaged!
• Glass plate(s) cleaning procedure; clean the glass regularly, we advice to
clean them with a product for cleaning windows (e.g.: glassex/IPA cleaner/... -
effectively removes both greasy and water-soluble dirt while being gentle on
materials) screening is on the inside of the glass, exterior is plain glass. Apply
the cleaner directly onto the area to be cleaned and quickly wipe off with a
soft, clean, lintfree cloth.In the case of delicate surfaces, apply the IPA cleaner
onto the cloth mentioned above and then wipe the surface.
• Regularly clean the glass wall(when necessary) , always use plenty of clean
water when cleaning glass to prevent scrubbing by dirt particles. Soft, clean
sponges, leather, cloths or rubber scrapers are, for example, suitable tools.
Careful handling of the glass cleaning tools is another condition for preventing
glass damage. The cleaning effect can be supported by the use of a largely
pH-neutral detergent or a commercially available glass cleaner for household
sealants, commercially available solvents such as spirit or isopropanol can be
used for cleaning. Of all chemical cleaning agents, alkaline solutions, acids
and fluoride-containing agents should generally not be used. The use of
sharp, sharp metal objects, eg knives or knives, can cause surface damage
(scratches).
The use of polishing machines is not permitted, especially for the glass walls.
A cleaning agent may not affect the surface appreciably. If damage to the glass
products or glass surfaces is detected during cleaning, the cleaning work must
be immediately interrupted.
DiBO 38