Additional Information; Troubleshooting - Megasat HD 370 Bedienungsanleitung

4. Main menu
3. Videos
On the left side of the screen you will see the con-
tents of your USB storage device. Navigate with
the pq buttons to select a folder in which you
saved videos. Then press the OK button to access
the folder.
Select a video with the pq buttons and start
playback by pressing OK. Playback look in advance
in the small preview window. Press the „YELLOW"
button to play the video in full screen mode.
Hinweis:
Eine allgemeine Steuerung wie. z. B. Start,
Stopp, vor- oder zurückspulen erfolgt über den
oberen Tastenblock auf der Fernbedienung.
4. HDD Information
Here you can see all the important information
about the inserted USB drive.
5. Storage Format
You can format the inserted USB drive.
ATTENTION: All files they reside on the USB drive
will be deleted irrevocably!
22
ENGLISH

5. Additional information

5.1 Troubleshooting

You might meet abnormal working of this STB with various reasons. Check the following which may
help you.
Problem Possible causes
The LED does not light up Power cable is not connected
No picture or sound. The dish is not properly aligned
with the satellite and therefore
receives a weak or no signal.
The LNB or the coaxial cable
is defective. You're not on the
right channel. (AV or HDMI)
Bad picture/blocking error Satellite dish is not aiming to
the satellite accurately. Signal
too strong. Satellite dish is too
small. LNB noise factor too
high. The LNB is faulty.
No startup menu on screen af- The system is connected by
ter turning on STB for the first HDMI cable and the TV is not in
time. HDMI mode.
The remote control is not wor- Battery
king. control is not aimed correctly
STB is in standby mode.
You have forgotten your pass-
word.
What to do
Check that the power cable is
connected properly.
Adjust the dish. Check the sig-
nal strength indicator in one of
the channels search submenus.
Check the cable connections,
LNB and other equipment
connected to LNB & receiver,
or adjust dish. Replace the LNB.
Replace the cable.
Adjust the dish. Connect an at-
tenuator to LNB input. Change
to a larger dish. Change LNB
with lower noise factor. Repla-
ce the LNB.
Switch the TV to the appropria-
te HDMI input.
exhausted. Remote Change the batteries (both).
Aim the remote control at the
STB. Check that nothing blocks
the front panel. Check if LED
indicator on the front panel is
showing the time, press the
power button to switch off
standby mode.
Contact the dealer or Service
Provider. They will help you set
it up again.
ENGLISH
23