Safety Instructions; Electrical Connection - Atag VA63211VT Benutzerinformation

by clients in hotels, motels, bed & breakfast and other
–
residential type environments.
Do not change the specification of this appliance.
•
The operating water pressure (minimum and maximum)
•
must be between 0.5 (0.05) / 8 (0.8) bar (Mpa)
Obey the maximum number of 15 place settings.
•
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Put knives and cutlery with sharp points in the cutlery basket
•
with the points down or in a horizontal position.
Do not keep the appliance door open without supervision to
•
prevent to fall on it.
Before maintenance, deactivate the appliance and
•
disconnect the mains plug from the mains socket.
Do not use water spray and steam to clean the appliance.
•
The ventilation openings in the base (if applicable) must not
•
be obstructed by a carpet.
The appliance is to be connected to the water mains using
•
the new supplied hose-sets. Old hose sets must not be
reused.

SAFETY INSTRUCTIONS

Installation
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Do not install or use the appliance where
the temperature is less than 0 °C.
• Obey the installation instruction supplied
with the appliance.
• Make sure that the appliance is installed
below and adjacent to safe structures.

Electrical connection

WARNING! Risk of fire and
electrical shock.
• The appliance must be earthed.
• Make sure that the electrical information
on the rating plate agrees with the
All manuals and user guides at all-guides.com
• Always use a correctly installed
• Do not use multi-plug adapters and
• Make sure not to cause damage to the
• Connect the mains plug to the mains
• Do not pull the mains cable to
power supply. If not, contact an
electrician.
shockproof socket.
extension cables.
mains plug and to the mains cable.
Should the mains cable need to be
replaced, this must be carried out by our
Authorised Service Centre.
socket only at the end of the installation.
Make sure that there is access to the
mains plug after the installation.
disconnect the appliance. Always pull
the mains plug.
3