Safety Instructions - Atag VA63313LT/A01 Benutzerinformation

by clients in hotels, motels, bed & breakfast and other
–
residential type environments.
Do not change the specification of this appliance.
•
The operating water pressure (minimum and maximum)
•
must be between 0.5 (0.05) / 8 (0.8) bar (MPa)
Obey the maximum number of 13 place settings.
•
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Put the cutlery in the cutlery basket with the sharp ends
•
pointing down or put them in the cutlery drawer in a
horizontal position with the sharp edges down.
Do not leave the appliance with the open door unattended
•
to avoid stepping accidentally onto it.
Before any maintenance operation, deactivate the
•
appliance and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to
•
clean the appliance.
If the appliance has ventilation openings in the base, they
•
must not be covered e.g. by a carpet.
The appliance is to be connected to the water mains using
•
the new supplied hose-sets. Old hose sets must not be
reused.

SAFETY INSTRUCTIONS

Installation
WARNING! Only a qualified
person must install this
appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Do not install or use the appliance
where the temperature is less than 0
°C.
• Follow the installation instruction
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Make sure that the appliance is
installed below and adjacent to safe
structures.
Electrical connection
WARNING! Risk of fire and
electric shock.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
3