Acoustic Signals - Atag VA63211VT Benutzerinformation

10
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously and
indicators , ,
to flash and the display is blank.
2. Press .
• The indicators
go off.
• The indicator
• The display shows the current
setting: e.g.
– The levels of rinse aid are from
0A to 6A.
– Level 0 = no rinse aid is
released.
3. Press again and again to change
the setting.
4. Press the on/off button to confirm the
setting.
Use of rinse aid and multi-
tablets
The factory setting of the rinse aid
dispenser is with the dispenser activated.
This means that the rinse aid dispenser
always releases rinse aid.
It is possible to deactivate the rinse aid
dispenser, in this case the dispenser will not
release rinse aid only if the option Multitab
is activated.
If the dispenser is deactivated and you do
not select the option Multitab, the dispenser
will release rinse aid.
The use of the option Multitab with the rinse
aid dispenser deactivated may not give
satisfying drying results.
When the rinse aid dispenser is
deactivated, the rinse aid indicator is always
off when the option Multitab is activated.
All manuals and user guides at all-guides.com
until the
, and start
, , and
continues to flash.
= level 4.
How to deactivate the rinse aid
dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously and
indicators , ,
to flash and the display is blank.
2. Press .
• The indicators
go off.
• The indicator
• The display shows the current
setting: = the rinse aid dispenser
is activated (factory setting).
3. Press to change the setting.
= the rinse aid dispenser is
deactivated.
4. Press the on/off button to confirm the
setting.

Acoustic signals

Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default this acoustic signal is deactivated
but it is possible to activate it.
How to activate the acoustic
signal for the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and hold
simultaneously and
indicators , ,
to flash and the display is blank.
2. Press
• The indicators
off.
• The indicator
until the
, and start
, , and
continues to flash.
until the
, and start
, , and go
continues to flash.