The Dual Blade; Control Switches - Cuisinart RMC100E Allgemeine Hinweise

N.B. The work bowl must be securely locked into position. The bowl will be in the correct position
once the handle is central to the control panel.
• Carefully lift the blade assembly, holding the central plastic stem and place over the motor
spindle. Push the blade down until it clicks into place. The lower part of the blade assembly
should almost touch the bottom of the work bowl.
N.B. Always hold the blade assembly from the plastic stem. Never touch the blade as it is very
sharp.
N.B. Never place the blade on the motor shaft until the work bowl is locked into place.
N.B. Always insert the blade in the work bowl, before adding ingredients.
• Add the food you wish to process.
• Place the lid on the work bowl with the small tab to the left of the work bowl handle. Turn the
cover clockwise (toward handle) to securely lock.
N.B. The work bowl and lid must be tightly locked into the interlock device. Once securely fitted
a loud click is heard. If both the work bowl and the lid are not fitted securely, the processor will
not work.
• To remove the lid, hold the housing base with your left hand, securely grip the handle on the top
of the lid and rotate it in a anticlockwise direction.
N.B. Make sure the motor has completely stopped and the blade has stopped moving before
removing the lid
ATTENTION: The lid must always be removed before fitting or removing the work bowl from the
base as the bowl will not fit with the lid attached.
• To remove the blade, gently pull up to disengage blade lock away from the motor spindle
holding the plastic stem.
• To remove the work bowl, firstly ensure the lid has been removed. Hold the housing base with
your left hand, then hold the work bowl handle with your right hand and turn in a anticlockwise
direction to unlock and lift away from the housing base.
C. THE DUAL BLADE
This appliance processes using a dual blade with a sharp, curved edge for chopping/mixing and
a flat, blunter edge for grinding.
Blunter edge
Sharp edge
D. CONTROL SWITCHES
To start operation, simply press one of the two switches and hold down for the desired length of
time.
Use the 'CHOP' speed switch for chopping, puréeing and mixing food with the sharp edge of the
blade.
21