Switching Off; Testing The Chain Saw And Battery; Checking The Chain Sprocket; Checking The Guide Bar - Stihl MSA 220 C Gebrauchsanleitung

English
► Hold the saw with your right hand on the grip
area (1) of the control handle – wrap your
thumb around the control handle.
► Depress the lockout button (2) with your
thumb and hold it there.
► Pull the trigger (3) with your index finger and
hold it there.
The motor is accelerated and the chain
rotates. Release the lockout button (2).
► Hold the saw with your left hand on the front
handle – wrap your thumb around the handle‐
bar.
9.2

Switching Off

► Release the trigger.
The chain stops rotating.
► If the chain continues to rotate: Engage the
chain brake, remove the battery and contact
your STIHL servicing dealer for assistance.
The saw has a malfunction.
10 Testing the Chain Saw and
Battery
10.1

Checking the Chain Sprocket

► Switch off the chain saw, engage the chain
brake and remove the battery.
► Disengage the chain brake.
► Remove the chain sprocket cover.
► Remove the bar and chain.
a
► Use a STIHL gauge to check the wear marks
on the sprocket.
► If wear marks are deeper than a = 0.5 mm: Do
not use your chain saw and contact your
STIHL servicing dealer.
The chain sprocket must be replaced.
10.2

Checking the Guide Bar

► Switch off the chain saw, engage the chain
brake and remove the battery.
► Remove the chain and guide bar.
44

10 Testing the Chain Saw and Battery

► Measure depth of bar groove with scale on
STIHL filing gauge.
► Install a new guide bar if one of the following
points applies:
– Guide bar is damaged.
– Measured bar depth is less than specified
minimum depth,
– Bar groove is pinched or splayed.
► If you have any queries: Contact your STIHL
servicing dealer.
10.3

Checking the Saw Chain

► Switch off the chainsaw, engage the chain
brake and remove the battery.
2
► Use a STIHL filing gauge (2) to check the
height of the depth gauges (1). The STIHL fil‐
ing gauge must match the chain pitch.
► If a depth gauge (1) projects from the filing
gauge (2): Lower the depth gauge (1),
2
4
► Make sure the service marks (1 to 4) on the
cutters are visible.
► If one of the service marks is not visible on a
cutter: Do not use your chainsaw and contact
your STIHL servicing dealer.
19.3.
1
16.3.
1
3
0458-795-9621-C