Agilent TPS-mobile Betriebsanleitung Seite 226

Instructions for Use
Display indications with Soft Start completed: the SOFT START MODE message no
longer appears on the display, the bar indicator either, the STARTING message is
replaced by the NORMAL message.
After 60 days or more of inactivity, in order to allow again the correct redistribution
NOTE
of the grease present in the bearings, it is necessary to start the pump via soft
start mode again.
If necessary, it is possible to reactivate the automatic soft start function of the
pump by using the front panel menu (AUTO SOFTSTART function) or by means of a
serial command (writing WIN190 = 1). In this way the turbopump, only at the first
start, will carry out a ramp of gradual pump boot exactly as it did at the first start.
The reactivation of the Automatic Soft Start function can only be carried out if you
are in STOP conditions.
Please refer to the controller's relevant instruction manuals in order to find
WARNING
the appropriate set of instructions to activate the "soft start" modality
(Remote: Chapter Technical Information – Controller Connection &
Window Meanings ; On Board: Chapter Technical Information –
Interconnections & Window Meanings).
226 Agilent TPS-mobile User Manual