A-2. Auto Cutter Specifications; A-3. Interface; A-4. Electrical Characteristics - Star TSP800-Serie Bedienungsanleitung

A-2. Auto Cutter Specifications

(1) Cutting frequency
(2) Thickness of paper

A-3. Interface

(1) Interface
(2) Command

A-4. Electrical Characteristics

(1) Input Voltage
(2) Current Consumption Operating: Approx. 1.8 A (at ASCII printing)
(3) Power Connector
Pin No. Function
1 Drive power
2 Signal GND
3 N.C.
Shell Frame ground
Important!
• When using a printer power supply other than the optional AC adaptor
(PS60-24A), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ±10% and more than 2.0 A (5.0 A Load
10 sec. Min).
• Be careful about installing the printer in an area where there is noise.
Take the appropriate measures to protect against electrostatic AC line
noise, etc.
All manuals and user guides at all-guides.com
Max. 20 cuts per minute
0.065 ~ 0.15 mm
RS232C serial interface or Two-way parallel inter-
face (IEEE1284)
Star commands
DC 24V±10%
Peak: Approx. 10 A (at print duty 100%)
Stand-by: Approx. 0.1 A
<Viewed from Connector Surface>
– 81 –
3
1
2